About three pinch device debugging is the most important, how can we put three pinch device commissioning work to do it, here Hongchuang high mold factory managers simply give you an analysis: 1, first three pinch equipment machines before and after the two corners line up the shaft from the big end of the frame in the end the amount of consistent height, and then routed to the last row from the first, to find a line straightened, check, whether under the shaft in a straight line, the next axis left and right sides into a level. 2, the three-dimensional pinch device in the first row and the last row to find a good center, and then tighten the lock on both sides of the mother, in front of the center in the middle rounds, after a good pull a straight line, the upper and lower shaft gap adjustment is completed, you can adjust the machine along a straight line. 3, three dimensional gusset plate devices, such as the right running board, pad left corner (feed rack), or off the right side of the bottom level, the first of several shaft axis deviation Ladi few flat bottom, with the bottom of the shaft axis whereabouts http: / / www.sanweikoubanty.com/.